Spindle control

  1. Customise Makita router - to be able to detach a cable from the spindle and to easily connect it a relay module. Spindle

  2. Add spindle control relay. Relay The mains power goin in (not connected on the photo above) and the controlled power output goes to the spindle.

Vacuum control

Arduino-based RF controller to wtich on and off a vaccum plugged into a RF controlled power socket. It’s connected to the PWM pin on the BlackBox so it reacts to M3/M5 G-Code commands.

Vacuum control

Blabk Box, Vacuum control and Spindle relay

BlackBox front panel